BACKLINE ENGINEERING
  • HOME
  • About
  • GEAR
  • APPS
  • Contact
  • FORUM

7 watts | Class-A | Programmable
.

Picture
Picture

ZenTone 7

ZenTone 7 is a seven watt class-A tube amp employing a classic 300V tube circuit design. It offers low power mode and/or output tube triode mode which can bring the output power down to 3 watts or about 1 watt. As a practice or recording amp, you can get great output tube overdrive at low volume settings or while sending the direct output signal to a mixing board or audio interface device. In addition, it provides the convenience of storing your tube amp settings in one of 64 preset locations effectively creating a 64-channel tube amp.

You can select a single stage preamp or a dual stage preamp using one of three preamp gain structures. It also contains a classic British tone stack design for that vintage sound. You can select between an EL84 output tube or a 6V6 output tube on the fly. With the internal speaker load and speaker emulation circuit, the XLR or unbalanced direct output captures the tone of the entire tube amp signal path including the output transformer without the need for an external speaker.
Use the included footswitch to select presets or select presets and other parameters from an external MIDI source. With the free Windows editing software, the amp can be completely controlled using MIDI. Additional features of ZenTone 7 are listed below.


DEMOS

All of the guitar parts in the following tracks were recorded using ZenTone7. They were recorded through the direct output and no overdrive or distortion pedals were used:
"Tomorrow" by Lapick
"Hit-n-run" by Lapick
"Leaving" by Lapick

Features

  • 7 watt class-A single-ended amp head (low power switch brings this below 3 watts)
  • Authentic 300V tube amp signal path based on classic designs
  • Two 12AX7 preamp tubes (substitute 12AT7, 12AU7, 12AY7, 12AZ7 for different tones)
  • Select between 3 preamp gain structures
  • Switch between EL84 or a 6V6 output tube with the push of a button
  • Select output tube Pentode mode or Triode mode for a darker tone with more compression and lower power
  • Gain, bass, mid, treble and master volume controls
  • Bright switch
  • All the above control values can be stored in 64 preset locations
  • Unbalanced and XLR direct outputs with level control
  • Direct out contains entire tube signal path from the input to the speaker output
  • Built-in classic Greenback reactive speaker load when external speaker is unplugged
  • Direct out has speaker emulation frequency curve
  • Direct out level control can act like a power attenuator allowing you to overdrive the output tube
  • Cycle through presets or different groups of presets using the included external footswitch
  • Preset zero is a true bypass from input to unbalanced direct output
  • MIDI input for selecting presets or controlling any parameter
  • DC tube filaments for reduced noise
  • Free Windows software for controlling the amp using MIDI
  • 12.5"W x 9"H x 9"D - Shipping weight: 15lbs

Documentation

  • Zentone7_manual_v2.1.pdf

Firmware/Edit

  • Preset Files (syx)
  • Windows Editing Software (exe)

Powered by Create your own unique website with customizable templates.
  • HOME
  • About
  • GEAR
  • APPS
  • Contact
  • FORUM